12/03/2026 12:40 pm
Topic starter
Notifications
Clear all
EF Mount Camera & Lens Forum
4
Posts
5
Users
0
Reactions
121
Views
0
I've been shooting for ages but just grabbed a T7 as a quick backup for a gig this weekend in Chicago and just realized the hotshoe is missing the center pin. Total amateur move on my part not checking but now my old triggers won't fire. My logic was any Canon trigger would work but clearly not with this weird setup. I've got a $100 budget and need something by Friday so I'm looking at the Godox X2T-C or maybe a Yongnuo? Some people say firmware fixes it but others say it's a hardware nightmare. Which wireless trigger actually works with the T7's missing pin out of the box? I'm kind of in a rush here...
4 Answers
12
12/03/2026 12:41 pm
In my experience, these work:
- Godox X2T-C Wireless Flash Trigger for Canon is reliable.
- Godox Xpro-C TTL Wireless Flash Trigger for Canon has better menus. They dont need the pin.
11
12/03/2026 1:45 pm
Building on the earlier suggestion, you gotta be really careful with the Yongnuo stuff. Tbh, most of their older units basically turn into paperweights on the T7 because they rely on that missing center pin for the signal. Canon really made it a headache for third-party gear. I would suggest looking at these two instead:
- Godox X3-C Compact TTL Wireless Flash Trigger
- Godox Xpro II-C TTL Wireless Flash Trigger The X3 is their newest tiny remote. It has a touchscreen and handles the missing pin natively. Its super portable for a backup kit and should stay under budget. The Xpro II is the beefier version with better menus but it might push your 100 dollar limit. Personally, I would grab the X3... its small enough to live in your bag forever and works out of the box. Just dont forget to check the firmware when it arrives so it syncs up perfectly.
2
13/03/2026 3:45 am
Following this thread
1
12/03/2026 1:15 pm
Quick reply while I have a sec... You gotta be really careful with that T7 hotshoe. Canon basically nuked compatibility for any universal manual triggers by removing that center contact point. If you try to use a standard single-pin trigger, it literally wont do anything because there is no electrical circuit being completed for the fire signal. A few technical things to watch out for:
- Avoid any triggers labeled as universal or manual only since they rely 100 percent on that missing middle pin.
- Check the pin layout on the foot of the transmitter to ensure it matches the E-TTL data pins.
- Some older units might need a firmware update via USB before theyll even recognize a pinless camera. Its basically a hardware gatekeep. If the trigger doesnt have the internal logic to reroute the fire command through the side data pins, youre gonna be stuck. Stick to triggers that specifically mention being compatible with the 2000D or 4000D series, or you might end up with a bricked setup for your gig...
